Back to the news page

Tpm Driver
Tpm Driver
Tpm Driver Error
Tpm Driver Dell
Tpm Driver Dell

12.08.2019

TPMS DIAGNOSTIC INFORMATION – GMC Sierra, 2004-2020

HID Device Driver from TPMX Electronics Ltd. this driver hasn't been added to the DRT as of this run. Please search Google/Bing for the driver if additional information is needed. Dtsoftbus01.sys Fri Jan 13 08: (4F10358A) Daemon Tools driver br Possible BSOD issues in Win7. WolfTPM uses the TPM Interface Specification (TIS) to communicate over SPI. WolfTPM can also use the Linux TPM kernel interface (/dev/tpmX) to talk with any physical TPM on SPI, I2C and even LPC bus. Platform support for Raspberry Pi, STM32 with CubeMX, Atmel ASF and Barebox. The design allows for easy portability to different platforms.

After the TREAD Act was mandated in 2007, all vehicles manufactured in the United States beginning in 2008, must be installed with direct or indirect TPMS systems.

The GMC Sierra is manufactured with a direct TPMS system, which means TPMS sensors are installed in the wheel. If one or more tires indicate low tire pressure, the TPMS sensors will transfer the information to the vehicle’s ECU. An indicator light (low-line TPMS system) or each tire pressure will show on the dash (high-line TPMS system).

When a sensor is replaced in one or more tires, one or more wheels are replaced or tires are rotated in a GMC Sierra, a manual (stationary) or OBD TPMS relearn is recommended to transfer new and/or existing TPMS sensor IDs to the vehicle’s ECU.

Type of TPMS system:

Direct TPMS, sensors are installed in the wheel
All OE and aftermarket TPMS part numbers and service kit replacement options for the GMC Acadia can be found in the VT56 in “Service TPMS”.

Type of TPMS frequency:

315 MHz for years 2004-2018
433 MHz for the year 2020
2019 models use both 315 MHz and 433 MHz frequencies

Type of Relearn Procedures:

Manual (stationary) relearn, years 2007-2020
Bonus OBD relearn procedure coverage as an option on the VT56, requires OBD module, years 2008-2020

Type of TPMS tool required for TPMS reset

VT56 TPMS Diagnostic tool, step by step relearn procedures are written in the tool.

Bonus coverage, OBD relearn procedure, years 2008-2020:

OBDII dongle is required
Confirm TPMS sensors are properly installed
Adjust tire pressures to placard value
Hold TPMS tool on left front tire sidewall next to valve stem
Repeat for RF/RR/LR tires
Apply OBD dongle to DLC
Turn ignition to ON
Press OK on TPMS tool to transfer data to ECU
Disconnect OBD dongle from DLC
Turn ignition to OFF then start the engine
Drive for at least 5 minutes at 28 MPH

The video shows a GMC Acadia, but the same procedure will work on a GMC Sierra.

Manual relearn procedure, years 2004-2007:

OBDII dongle is not required
Confirm TPMS sensors are properly installed
Adjust tire pressures to placard value
Apply parking brake
Turn ignition to ON
Turn headlight switch from OFF to parking lamp 4x within 4 seconds
Double horn chirp
Use tool to activate LF sensor
Single horn sounds
Repeat for RF/RR/LR
Turn ignition OFF
Drive vehicle for 2 minutes about 25 MPH to get correct DIC display
If learn mode can’t be enabled, see service manual
Release parking brake before driving vehicle

Manual relearn procedure, Keyless Entry, years 2008-2013:

OBDII dongle is not required
Confirm TPMS sensors are properly installed
Adjust tire pressures to placard value
Inflate all tires
Turn ignition ON
Push and hold unlock and lock button on key fob until horn sounds
Use tool to activate LF sensor
Single horn sounds
Repeat for RF/RR/LR
Turn ignition OFF

Manual relearn procedure, DIC Button, years 2008-2013:

Inflate all tires
Apply parking brake
Turn ignition ON
Push the DIC information button until PRESS TIRE LEARN is displayed
Push (✓) to confirm
Horn sounds 2x and TIRE LEARNING ACTIVE is displayed
Use tool to activate LF sensor
Single horn sounds
Repeat for RF/RR/LR sensor
Turn ignition OFF
Release parking brake before driving vehicle

Manual relearn procedure, Odometer Reset years 2008-2013:

Inflate all tires
Apply parking brake
Turn ignition ON
Push and hold the trip odometer reset stem on instrument panel until PRESS (✓) TO RELEARN TIRE POSITIONS is displayed
Push (✓) to confirm
Horn sounds 2x and TIRE LEARNING ACTIVE is displayed
Use tool to activate LF sensor
Single horn sounds
Repeat for RF/RR/LR
Turn ignition OFF
Release parking brake before driving vehicle

Manual relearn procedure, Uplevel DIC years 2014-2020:

OBDII dongle is not required
Confirm TPMS sensors are properly installed
Adjust tire pressures to placard value
Apply parking brake
Turn vehicle to ON/RUN
Scroll to the uplevel on the right side of the steering wheel until Tire Pressure is displayed
Push and hold Set/Reset button
Horn chirps 2x DIC displays TIRE LEARNING ACTIVE
Use tool to activate LF sensor
Single horn sounds
Repeat for RF/RR/LR
Horn chirps 2x for relearn complete

Manual relearn procedure, Base level DIC years 2014-2020:

OBDII dongle is not required
Confirm TPMS sensors are properly installed
Adjust tire pressures to placard value
Apply parking brake
Turn vehicle to ON/RUN
Push the trip odometer reset stem until Tire Pressure is displayed
Push and hold trip reset stem to begin the sensor matching process
Push trip reset again to confirm
Horn chirps 2x DIC displays TIRE LEARNING ACTIVE
Use tool to activate LF sensor
Single horn sounds
Repeat for RF/RR/LR
Horn chirps 2x for relearn complete

Troubleshooting tips

Tip 1:

The owner’s manual on the GMC Sierra states, “There are two minutes to match the first tire/wheel position, and five minutes overall to match all four tire/wheel positions. If it takes longer, the matching process stops and must be restarted.”

If the horn chirps twice before all steps have been performed or sensors have been activated, the relearn procedure most likely has failed and the IDs did not transfer correctly, which means the procedure has to start over again.

The solution? For most GMC vehicles, the bonus OBD relearn procedure is available for the ATEQ

Tpmx Driver